Three versions of Dual Magnetic Converters (DMCs) are available (A, C and D). DMCs convert magnetic style signals to an open collector output signal (square wave). This makes a typical magnetic sensor behave as a switched or hall effect sensor, thus making the signals suitable for use with ECUs and loggers. A single DMC can convert two independent magnetic sensor signals.

INTENDED USE :

This DMCA, is intended for use with fuel flow sensors that have a very low trigger level.

OPERATION :

For fuel flow application, the polarity of the sensor connection is generally not important since the signal is generally a sine wave. The measuring equipment should be configured to use the negative going edge if possible; however, positive going edge will also generally work satisfactorily. To minimise the possibility of interference at very low trigger levels, this model includes heavy filtering that results in significant variation of the trigger level with frequency. The variation is tailored to match a typical flow sensor, where the output signal increases as the frequency increases.

BASIC SPECS :

Physical

  • Built into Deutsch DTM04-12P connector housing
  • Deutsch DTM06-12S (MoTeC #68058) connector

Ambient Operating Temperature

  • -10 °C to 85 °C

Input resistance

  • 56 kΩ

Maximum input voltage

  • 80 Vpp

Minimum input signal level required for triggering

Frequency (Hz) Peak to Peak level (mVpp)
<=10 40
100 65
200 105
500 240
1000 490
Brand MoTeC

More From This Category