The ADR2 is MoTeC's second generation Accident Data Recorder. It records critical data from vehicle accidents, such as lateral, longitudinal and vertical accelerations. This data can help to better understand forces in high impact collisions and may assist with the medical assessment of drivers.

The ADR2 captures minimum 30 seconds of data per event, including 15 seconds immediately before the accident which triggered recording. Subsequent impacts extend the event recording time.

The device can be used stand-alone or in conjunction with other devices such as a GPS, Display Logger or ECU.

The MoTeC ADR2 conforms to FIA standard 8872-2018 and is included in the FIA ADR Program.

ADR2 MANAGER SOFTWARE :

The ADR2 Manager application requires Windows 10, 64 bit.

The software is used to:

  • Configure the device (password protected, FIA access only)
  • Download data
  • Format the ADR2 to erase stored events (password protected, FIA access only)
  • Update the firmware

FEATURES :

  • Configurable thresholds to trigger an event - password protected feature
  • Configurable thresholds to trigger the medical light output - password protected feature
  • Pre-event data capture of 15 seconds
  • Total event data capture of minimum 30 seconds
  • Support for external medical and status lights
  • CAN and GPS inputs for data recording
  • Internal backup power to continue recording if power is lost
  • Real time clock for accurate time keeping
  • Password protection restricts selected features to FIA access only

BASIC SPECS :

Communications

  • CAN for transmitting and receiving FIA specified data
  • RS232 for receiving GPS data
  • USB for communication with ADR2 Manager

Connectors

  • 1 x 13 pin Autosport connector size 10

Physical construction and dimensions

  • Case size: 86 mm x 45 mm x 25 mm
  • Case material: anodized aluminium
  • Ingress protection rating: IP66 / IP67
  • Operating temperature: -40 to 85 °C
  • Weight: 130 g

Power

  • Power supply: 6 – 32 V
  • Current: nominal 200 mA @ 12 V (with external GPS), maximum 1 A when charging backup power supply
  • USB power when connected to PC (when no other power source connected)
  • Backup power supply
    • provides power for at least 45 seconds of continued recording after vehicle power is lost
    • recharges in less than one minute after vehicle power is applied

Medical and status light outputs

  • Topology: current limited open collector high-side drive

  • External load: LED to GND or logic level input with pull-down resistor

  • Voltage on: 5 V - Regulated

  • Voltage off: 0.3 V (with external 10k load to ground)

  • Voltage off: 2 V (approximately, when not connected)

  • Current Limit: 20 mA

  • Reverse polarity protected

  • Voltage diagnostic feedback

Operational

  • Recording of lateral, longitudinal and vertical accelerations at 3000 Hz
  • Recording of CFC60 filtered acceleration data at 1000 Hz
  • Acceleration channel resolution: 0.125G
  • Recording of FIA specified CAN channels
  • GPS data recorded:
    • Date and Time
    • Latitude and Longitude
  • Accelerometers range: -480G to +480G
  • Accelerometers overload: 1800G minimum
  • Pre-accident recording: 15 seconds
  • Total event recording: minimum 30 seconds, extended on subsequent impacts
  • Data output format: CSV
Brand MoTeC

More From This Category